Dry & Wet Rot Fungal Decay of Timber
Dry & Wet Rot Fungal Decay in Building Timber
The most well known fungi found in buildings are Serpula lacrymans the True dry rot fungus and range of Wet rot fungi such as Coniophora puteana the Cellar fungus and Poria vaillantii the Pore or Mine fungus. Many other fungi also occur and some have recently been particularly linked with decay in door and window frames. Dry & Wet rot Fungal decay affects buildings of all ages and if decay is discovered it should be identified and remedial action taken without delay.
Both Wet & Dry rot Fungal decay always occurs because the wood has become wet, this can be from a wide variety of building defects. Once timber has a moisture content in excess of 20 per cent the timber is considered at risk and if other suitable conditions are there decay will occur. Finding the source of dampness and eliminating the ingress of moisture and promoting drying is always necessary.
Dry Rot & Wet Rot How it Grows
Dry rot is only caused by Serpula lacrymans and is the most serious form of fungal decay in a building. It can spread onto and destroy much of the timber. Wet rot occurs more frequently, but is less serious; decay is typically confined to the area where timber has become and remains wet.
Outbreaks of dry rot and wet rot start in similar ways. The mature fruiting bodies of wood-destroying fungi that develop during an attack produce millions of microscopic spores and these are widely dispersed by air currents. If they fall on untreated damp wood they will germinate by pushing out a hollow tube called a hypha which grows and branches to form a mass of hyphal threads called Mycelium. Mycelium develops inside the timber and breaks down the wood for food. The timber may darken in colour and develop a characteristic cracked appearance. Some wet rots may result in bleaching of the wood; these are more common in doors and window frames. Eventually, the wood loses its strength and in some situations may become dangerously unsafe.
The main differences between dry rot and wet rot are the degree of development of Mycelium on the wood surface and the ability of the fungus to spread into other timbers via adjacent masonry. It is important that the two types of decay be distinguished since they require different treatment.
Serpula lacrymans develops extensively on the surface of infected timber and in still, humid conditions produces a mass of cotton wool-like growth. Water droplets are often produced on the surface of the Mycelium.
Mycelium spreads over the timber surface by the continued growth and branching of the delicate hyphal threads growing with time. Specialised strands develop within the Mycelium and these supply water and nutrients to the growing fruiting bodies. The strands assume their real significance when the fungus spreads from infected timber onto the surface of adjacent stone or brick walls. The tiny hyphal threads penetrate the mortar joints and plaster layers and large areas of damp wall or building can then become infected.
This type of rot is caused principally by Coniophora puteana. Poria vaillantii is another important wet rot fungus and a number of less common fungi also occur. While each fungus has its own unique features, the general appearance of wet rot is similar – as is the treatment. Wet rot is typically confined to the area of dampness because the Mycelium does not spread into walls.
Identification and Treatment
As we have shown it is very important that the type and cause of the fungal decay are correctly identified before any corrective action can be considered. It is for these reasons that it is important that a detailed diagnostic inspection is carried out by a competent surveyor. This inspection should be followed by the submission of a report that details both the cause of the decay and the proposed remedial action. This is the starting point for remedial works to begin. Often there will be woodworm also present and the correct identification of Common Furniture Beetle or wood borer is vital to eradicating the infestation.